Painting the Saxon Cuirassier Bust Step by Step: Kuirassier Regiment von Zastrow

Kevin, better known as "Nap" on planetFigure, has just finished our 1/12th Saxon Cuirassier bust as a trooper of the Kuirassier Regiment von Zastrow. He logged the whole build on the forum, so here it is condensed into a step-by-step you can follow on your own kit. All paints are Vallejo unless stated, and all credit for the method goes to Kev.

The kit

The Saxon Cuirassier (BE/08) is a multi-part resin bust sculpted by Robert Lane. The crested helmet and black front-only cuirass make it stand out from the usual Napoleonic heavy cavalry.

Step 1: Gather references

Kev started by collecting helmet, breastplate, trooper and officer references before touching a brush. They paid off: several of the later changes came straight from comparing the casting against period plates and other painters' versions.

Step 2: Prep, extra details and basecoat

  • Mount the bust on its base and lay in the base colours.
  • Add the belt that supports the cuirass.
  • Optional conversions Kev made with green stuff putty: a rosette and oak leaves on the helmet, a neck protector on the lower rear edge of the helmet, a centre line on the epaulettes, and a re-sculpted shield on the cross belt.

Step 3: The colour recipes

White uniform

  • Base: Deck Tan 986
  • Shadows: German Beige 821
  • Highlights: base mixed with Ivory 918
  • Final highlights: Ivory 918

Yellow facings

  • Base: Yellow Ochre 913
  • Shadows: Earth 983
  • Highlights: Ice Yellow 858

Step 4: Eyes and flesh

Paint the eyes first, then build up the flesh. Kev used Jo Sonja acrylics for the skin and gave the hair a greying tone to suggest an older trooper.

Step 5: Helmet

Work through the helmet metalwork, then the plume, the oak leaves around the lower band and the rosette (white with a green ring). Kev went back over the decorative lower band a second time once the rest of the head was done.

Step 6: Collar, facings and uniform shadows

Lay in the shadows on the white uniform, then paint the collar and the yellow edging around the cuirass. Leave the white itself until the very end so it stays clean.

Step 7: The black cuirass

Paint the securing chains, the studs around the edge and the central crowned motif. Kev repainted the crown when it looked too dull against the black, so push the brightness there.

Step 8: The cross belt

This took the most attempts. Kev's first pattern of fine lining with dots ended up too busy, so he stripped it back and started again. The version that worked:

  1. Repaint the belt in the base colour.
  2. Add two yellow lines down the centre.
  3. Paint the lion's head and shield fittings.
  4. Keep the outer edging white.
  5. Finish the rear of the belt, the back straps and the buckles.

The lesson: keep the pattern simple at this scale.

Step 9: Finish the whites

With everything else done, complete the white uniform using the recipe above, tidy the base, and it is ready for the cabinet.

See the photos

Kev's work-in-progress and finished photographs are on PlanetFigure:

Paint your own

The kit is available here: Saxon Cuirassier 1/12th bust (BE/08).

Leave your comment

*
Only registered users can leave comments.